Call to chat to our team Find your
nearest location

Product available in: Vic, Sa, Qld

CA2S-E steel

Skin-passed commercial drawing steel for moderate forming and pressing with a surface suitable for exposed applications. Typically used for office furniture and
shelving.

Standards
AS/NZS 1595:1998
AS/NZS 1365:1996

Grades:
Standard Widths: 150mm to 1550mm
Standard Thickness: 0.5mm to 3.2mm

CA3SN-G steel

Skin-passed deep drawing steel guaranteed non-ageing and free from stretcher strain with general-purpose surface. Suitable for exposed drawn parts for automotive and appliance end uses.

Standards
AS/NZS 1595:1998
AS/NZS 1365:1996
Standard Widths: 150mm to 1550mm
Standard Thickness: 0.6mm to 3.2mm

OTHER GRADES AVAILABLE
CA4A-G steel
CA5SN-E steel
CA85T-G steel
CA250T-G steel
CM350-G steel
CU200T-G steel
CV2S1 steel (enamelling grade)
CV4S2 steel (enamelling grade)

Enquire about Product

ADVERSE CONDITIONS
If material is to be used within 1km of salt marine, industrial or corrosive environments please contact our Apex sales staff.

WARRANTIES
Our products are supported by Bluescope Steel Limited and a full warranty is available.

LENGTHS / TRANSPORT
Apex Building Products can custom cut lengths to your requirements. Due to transport restrictions it is advisable to check with our office the maximum length.

HANDLING
Care should be taken at all times when handling Corrugated. Packs must be kept dry and stored above ground level, should the sheets become wet separate immediately and individually wipe and place in an area to dry.

COMPATIBILITY
ZINCALUME® steel sheeting is compatible with most roofing products. It is NOT recommended to use lead flashing/nails, copper or copper alloy materials with or in run-off situations.

CUTTING
Apex Building Products provides this service, however sheets may be cut using a power saw with a metal cutting blade. COLORBOND® steel sheeting must be cut with the coloured surface facing the ground. Ensure that no hot particles or debris come into contact with the COLORBOND® .

CLEAN UP
To prevent premature corrosion at the completion of each day ensure the sheeting area is cleared of all debris, including nails, rivets, rags and all cutting or drilling filings.

DELIVERY
Apex Building Products delivers to site within 1 to 2 days. To prevent any damage we require suitable arrangements to be made for unloading. Unloading by crane, ensure the load is evenly spread, if crane unavailable adequate manpower is required.